Single Point Urban Interchange Design And Operations Analysis

Author : Carroll J. Messer
Publisher : Transportation Research Board
ISBN 13 : 9780309048682
Total Pages : 116 pages
Book Rating : 4.80/5 ( download)

DOWNLOAD NOW!

Download or read book Single Point Urban Interchange Design and Operations Analysis written by Carroll J. Messer and published by Transportation Research Board. This book was released on 1991 with total page 116 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Author :
Publisher :
ISBN 13 :
Total Pages : 101 pages
Book Rating : 4.33/5 ( download)

DOWNLOAD NOW!

Download or read book Single Point Urban Interchange Design and Operations Analysis written by and published by . This book was released on 1991 with total page 101 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Author : Nicholas J. Garber
Publisher :
ISBN 13 :
Total Pages : 116 pages
Book Rating : 4.95/5 ( download)

DOWNLOAD NOW!

Download or read book Comparison of the Operational and Safety Characteristics of the Single Point Urban and Diamond Interchanges written by Nicholas J. Garber and published by . This book was released on 1996 with total page 116 pages. Available in PDF, EPUB and Kindle. Book excerpt: The purpose of this study was to evaluate and compare the safety and operational characteristics of the single point urban interchange (SPUI) and the diamond interchange (DI) and develop guidelines that identify traffic and/or geometric conditions that favor one type of interchange over the other. State traffic engineers across the country were surveyed as to their experiences and opinions of the two types of interchanges in terms of operational performance and safety. Accident and operational data were also obtained for nine SPUIs and eight DIs. The interchange operations were studied using both field data and the computer simulation program TRAF-NETSIM. In addition, for each DI simulated, an SPUI counterpart was designed with the same geometric and traffic conditions for further comparison. No significant differences were found in the off-ramp, cross road, and overall interchange average delay. Ten volume scenarios were then developed and simulated for both interchanges at low- and high-volume conditions to analyze the effect of various traffic patterns on the relative operational performance of each interchange type. The accident data for the SPUIs and DIs were compared according to severity, collision type, and location on the interchange. No significant differences were found between the severity distribution and rates of the two interchange types. However, the proportion of on-ramp and off-ramp accidents was greater at the SPUI, and the proportion of accidents occurring in the center of the signalized intersection was greater at the DI. The proportion of angle accidents was greater at DIs than at SPUIs, whereas the proportions of rearend on-ramp, sideswipe, and fixed object accidents were greater at SPUIs. Vehicle conflicts at four interchanges in Virginia were also investigated and used along with the accident analysis results. The operational results, safety analyses, literature review, and survey of state engineers were used to develop guidelines to aid traffic engineers in the selection and design of the appropriate interchange type.

Author : James A. Bonneson
Publisher :
ISBN 13 :
Total Pages : 74 pages
Book Rating : 4.98/5 ( download)

DOWNLOAD NOW!

Download or read book A National Survey of Single-point Urban Interchanges written by James A. Bonneson and published by . This book was released on 1989 with total page 74 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Author : Rawan Ramadhan
Publisher :
ISBN 13 :
Total Pages : 52 pages
Book Rating : 4.81/5 ( download)

DOWNLOAD NOW!

Download or read book Comparison of Single Point Urban Interchange and Diverging Diamond Interchange Through Simulation written by Rawan Ramadhan and published by . This book was released on 2019 with total page 52 pages. Available in PDF, EPUB and Kindle. Book excerpt: In 1960, there were 74,431,800 vehicles registered in the United States. Looking at the most recent data currently available shows that in 2016 there were 268,799,083 registered vehicles in the United States. Roadway facilities constructed in the 1960s were not designed to handle vehicular traffic of these proportions. The ever increasing volumes of motor vehicle traffic at heavily traveled interchanges and intersections heighten the risk of single or multiple vehicle crashes particularly when they are not designed to manage high volumes. Traffic engineers from state and federal departments of transportation have responded to calls for safer roads and interchanges in some areas that have been identified as dangerous because of an increase in fatal and non-fatal motor vehicle crashes. In the road network the highway system and the local street system are related. According to the Federal Highway Administration, "the term interchange means the junction of two or more streets requiring partial or complete grade separation." Interchanges located in urban areas are utilized to facilitate traffic flow between arterial roadways and freeways on- and off-ramps. Congestion and safety are the two main objectives traffic engineers consider while remodeling an interchange design. Several types of renovated interchanges are normally considered to meet the growing population mobility needs. The Single Point Urban Interchange (SPUI) is one of the solutions has been considered since 1974 but it was flourished and implemented in the 1990s. The other innovative interchange solution appeared first in France in the mid-1970s known as Diverging Diamond Interchange (DDI). Likewise, the DDIs did not gain popularity back then until in the 2000s. The first DDI in the United States was constructed in 2009 in Springfield, Missouri.The main aim of this study is to compare the performance of traffic flow between SPUI and DDI based on existing traffic data for a peak hour retrofitting an existing Conventional Diamond Interchange (CDI). The analysis of the two interchange designs in conjunction with the existing design are used in the comparison study to identify which interchange design performs best among each other. The Measures of Effectiveness (MOEs) used in this study include queue delay, queue length, vehicle delay and stopped delay. This study obtain traffic turning movements and signal timing data from the Ohio Department of Transportation (ODOT). The turning movement counts (TMC) were taken from ODOT's Transportation Data Management System for the year 2017. VISSIM version 11 software was used for microscopic simulation. The optimum signal phasing for the three interchange designs were obtained from SYNCHRO 10 software based on the PM peak hour traffic data. The virtual interchange network design geometry in both software programs were almost identical. Several assumptions were made to stay consistent as much as possible while comparing the three designs since they have completely different geometric layouts. For example, the existing CDI data included the through movements from off-ramps to on-ramps. Since the two alternative designs (SPUI and DDI) exclude the through movements from off-ramps to on-ramps, their data were added to the right turn movements. Moreover, the speed limit was set to be in the range of 30 mph while driving in the interchange to meet all three design specifications.The analysis of results show that there are significant advantages and disadvantages associated with each design (CDI, SPUI and DDI). During implementation, various factors such as cost, efficiency, safety, delay, etc., need to be considered when attempting to select the best design, which would be the most appropriate method as these may vary from situation to situation. However, in the current study, a DDI performed best, followed by a SPUI, and then CDI was last. Moreover, CDI with its signal timing optimized very highly improved all MOEs considered when compared with the CDI with existing signal timing.

Author : Jim C. Lee
Publisher :
ISBN 13 :
Total Pages : 218 pages
Book Rating : 4.08/5 ( download)

DOWNLOAD NOW!

Download or read book Evaluation of Operational Efficiencies, Cost, and Accident Experience of Four Phase Single Point Urban Interchanges written by Jim C. Lee and published by . This book was released on 2002 with total page 218 pages. Available in PDF, EPUB and Kindle. Book excerpt: This research compares two interchange types, the Tight Urban Diamond Interchange (TUDI) and the Four Phase Single Point Urban Interchange (40SPUI). The 40SPUI is referred to in this report as a Single Point Urban Interchange with Frontage Roads (SPUI/F). The objectives of this research were to: (1) evaluate the SPUI/F based on available accident data and conflict analysis techniques, right-of-way and construction costs, and operating efficiency; (2) compare the performance of the SPUI/F and the TUDI; (3) evaluate current SPUI/F design assumptions and operation and recommend design and/or operational changes to enhance performance; and (4) evaluate the interchange form selection (pre-design) process and recommend changes where appropriate. The research found no significant difference in the safety aspects of the two interchange types. The SPUI/F generally did not perform as well operationally as the TUDI, with increased SPUI/F delay as the distance between frontage roads increased.

Author : Rui Yue
Publisher :
ISBN 13 : 9780355052558
Total Pages : 55 pages
Book Rating : 4.55/5 ( download)

DOWNLOAD NOW!

Download or read book An Evaluation of Operational Efficiency Between Single Point Urban Interchange with Frontage Road and Tight Diamond Interchange written by Rui Yue and published by . This book was released on 2017 with total page 55 pages. Available in PDF, EPUB and Kindle. Book excerpt: Signalized urban interchanges are frequently used as junctions between freeways and local arterials to date. In recent years, many new interchange or intersection designs like Diverging Diamond Interchange (DDI) and Continuous-flow Intersection (CFI) have emerged across the world. However, most of the interchanges are still using conventional urban interchange designs. Among new designs, Single Point Urban Interchange (SPUI) and Tight Diamond Interchange (TDI) are the most popular. Comparison and evaluation of the safety and operation of interchanges are important in transportation engineering to choose the most appropriate option for a location. Recently, many research have been devoted to the standard TDI and SPUI. Most of them consistently prove that the SPUI outperforms TDI in operation efficiency, but few research have compared the SPUI with frontage road (SPUI-F) with TDI. This research aims to fill this gap. With this motivation, there was a real case which could be used as testing the operational efficiency between the TDI and SPUI-F. The Nevada Department of Transportation (NDOT) switched the TDI, which was located at I-580/Plumb Ln, to SPUI-F in 2003. Since this interchange has experienced TDI and SPUI-F, the Measures of Effectiveness (MOEs) for each of them can be compared. To perform this comparison, layouts of both interchanges were modeled in VISSIM. The models were calibrated using the existing volume. Several volume scenario groups were designed for testing the operational efficiency of both options. Three MOEs, including average delay, average speed and average queue length, were selected to show the operational efficiency. The results revealed that the TDI is more efficient in comparison to the SPUI-F. However, TDI might not satisfy the driver’s expectation because of the stopping between the two signals, for which SPUI-F does not have such a problem.

Author :
Publisher :
ISBN 13 :
Total Pages : 100 pages
Book Rating : 4.13/5 ( download)

DOWNLOAD NOW!

Download or read book Design and Operational Features of the Single Point Urban Interchange. Final Report written by and published by . This book was released on 1991 with total page 100 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Author : James Allen Bonneson
Publisher :
ISBN 13 :
Total Pages : 482 pages
Book Rating : 4.17/5 ( download)

DOWNLOAD NOW!

Download or read book Operational Characteristics of the Single-point Urban Interchange written by James Allen Bonneson and published by . This book was released on 1990 with total page 482 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Author : National Research Council (U.S.). Transportation Research Board
Publisher :
ISBN 13 :
Total Pages : 184 pages
Book Rating : 4.65/5 ( download)

DOWNLOAD NOW!

Download or read book Intersection and Interchange Design written by National Research Council (U.S.). Transportation Research Board and published by . This book was released on 1993 with total page 184 pages. Available in PDF, EPUB and Kindle. Book excerpt: